Okay Egg Man I finally finished my Jockey. Heres a pic. I used a paper towel dispenser from walmart that I had in the kitchen. It was already 7/8 diameter perfect for the clutch lever I took the stock cable and stripped all the insulator off and pulled the cable all the way out. I then measured the distance I needed from housing to lever and made my cut on the sheath. I left the same amount of exposed cable the factory had left and made the proper adjustments to the cable I then resoldered the end back on the and vwalla.. Just a little something I thought was pretty cool. It is extremely light weight and does not vibrate hardly at all. The ball is threaded so I can remove it if I want and put something else on any time I want.
Also just for fun a pick of my front fender converted to rear fender and my Nobby 18inch Low Profile Rear Tire.